Parkside SET PSPP 5 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 8

Once the plasma burner button has been pressed the pilot arc will be

ignited immediately.
Keep away from the burner tip.

Never point the plasma burner at yourself or other people!

 Using the device
 Connecting the cutting burner
NOTE:
Always observe the operating instructions for the main device. The parts marked * can be found in the operating
instructions for the main device.
Before connecting the burner unplug the mains plug* of the plasma cutter* from the socket.

Insert the plasma burner plug

hand-tight.
Insert the plasma burner control plug

hand-tight.
 Connecting the earthing cable
Connect the earthing clamp device plug

Then connect the earthing clamp plug* with the earthing clamp connecting plug

connecting shaft is fi rst connected and then turned. The connecting shaft of the earthing clamp device
plug must point upwards when plugging in. After plugging in, the connecting shaft must be rotated
9
in a clockwise direction until it reaches the stop, in order to lock it in place. This does not require force!
 Operation
Compared with working with the plasma burner delivered with the product, please note the following:
Position the plasma burner
forwards to lock the plasma burner button
ignited. After each use, push the safety switch
 Explanation of pilot ignition
Pressing the plasma burner button
the burner sleeve . This enables contactless cutting of the workpiece. Grills and gratings can also be cut in
4
this way.
NOTE:
The safety switch must always be in the rear position if you are not plasma cutting at that particular moment.
11
The plasma burner button
 Maintaining the burner
Switch the plasma cutter* off before carrying out any maintenance work using the On/Off switch, unplug

the mains plug* from the mains socket and push the safety switch
The consumables displayed in Figure C are the electrode

once the nozzle clamping sleeve
The electrode must be replaced if there is a crater of approximately 1.5 mm depth in the centre.
3

ATTENTION! To unscrew the electrode, do not apply irregular pressure, gradually increase pressure until

the electrode comes out. Then screw the new electrode into the holder.
8 GB/IE/NI/CY/MT
into the plasma burner connection socket "-"* and tighten the union nut
10
into the plasma burner control socket* and tighten the union nut
7
with the earthing clamp connecting socket "+"*.
9
on the workpiece such that the spacer is in full contact. Push the safety switch
1
in place. Press the plasma burner button
2
11
will ignite a pilot arc. The result of this is a plasma beam at the tip of
2
is then locked in place.
2
has been unscrewed.
5
backwards to lock the plasma burner button
11
and the burner sleeve
3
. Make sure that the
8
. The cutting arc is
2
backwards.
. They can be replaced
4
11
in place.
2