Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Reassemble the filters in the reverse
order of the disassembly, replace the
filter insert, and rotate clockwise to
the close arrow.
Install the lower spray arm back.
WARNING
Do not over tighten the filters. Put the filters back in sequence securely, otherwise
coarse debris could get into the system and cause a blockage.
Never use the dishwasher without filters in place. Improper replacement of the filter
may reduce the performance level of the appliance and damage dishes and utensils.
Spray arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
1. To remove the upper spray arm, hold
the nut, rotate the arm clockwise to
remove it.
3. Wash the arms in soapy and warm
water and use a soft brush to clean
the jets. Replace them after rinsing
them thoroughly.
NOTE
• When removing or installing the lower
spray arm, first flatten the spray arm
as shown.
• Hold the spray arm while holding the
bottom nut at the same time to prevent
the spray arm from rotating.
• When installing the lower spray arm,
press the spray arm down to make it
fasten after alignment.
• Do not disassemble the spray arm after
unloading it. It is difficult to reassemble
after disassembling.
2. To remove the lower spray arm, pull
out the spray arm upward.
36
EN
Werbung
