Cleanmaxx SG55106 Gebrauchsanleitung Seite 25

Steam Burst / Vertical Steam-Ironing
CAUTION!
■ Make sure when doing vertical ironing that there is plenty of space around the item
of clothing which is to be ironed. You may only perform vertical ironing if the item of
clothing is hanging on a hanger and cannot come into contact with other garments,
objects, people or animals.
■ Iron the laundry only in places where heat and moisture cannot do any damage, e.g.
NOT in front of wallpaper, windows or mirrors.
In addition to conventional steam-ironing, the iron can also emit a strong burst of steam,
e.g. for smoothing stubborn creases or textiles which are hanging up.
As the temperature drops quickly with this function, we recommend that the iron
should be attached to the mains cable and connected to the mains power.
5. Press the steam burst button (12), move the bottom of the iron (8) a little in front
of or on the fabric and then release the button again.
6. Wait a few seconds before you press the button again. NOTE: The lower the ironing
temperature, the weaker the production of steam and the longer it takes for more
steam to be produced.
Spray Function
The spray function is suitable, for example, for moistening delicate textiles which cannot
be steam-ironed. This function is independent of the steam function and is possible at
any temperature. NOTE: The water reservoir must have been fi lled (see the "Filling the
Water Reservoir" section).
After Use
1. Once you have fi nished ironing, move the steam quantity control to position 0 and
the temperature control to position MIN (off).
2. Place the device on the adapter or vertically onto the base.
3. Remove the mains plug from the plug socket.
4. Allow the bottom of the iron to cool down completely.
25
1. Make sure that the water reservoir has been fi lled.
2. Heat up the device.
3. Use the steam quantity control to set the quantity of steam
you want (0 – max). You can now start ironing.
4. When performing vertical steam-ironing on delicate fab-
rics, hold the iron a few centimetres away from the fabric.
• Press the spray button (13) a few times. Water will be
sprayed through the spray nozzle (9) onto the fabric.
EN