Silvercrest SHLF 2000 D3 Bedienungs- Und Sicherheitshinweise Seite 14

˜ Turning on the product
Connect the power plug
socket-outlet.
Activating the standby mode: Set the on/off
to I. A short beep sounds. The
switch
[ ]
display shows the room temperature
6 ] [
and the timer indicator
Turning on the product: Press
product switches to automatic heating level
( ) operation mode.
NOTE: When the product is in operation, the
control lamp is lit.
[ ]
˜ Turning off the product
Switching to standby mode: Press
NOTE: The fan continues to run for about
another 4 to 5 seconds. Afterwards, the
product turns off and the control lamp
out.
Turning off the product fully: Set the on/off
to 0.
switch
[ ]
˜ Control panel/Remote control
Press the buttons on the control panel
use the remote control
NOTE: In standby mode, no settings can be
made. First, switch on the product by pressing
/ .
8 ] [ [ ]
Button
/
3 ] [ [ ]
/
4 ] [ [ ]
/
5 ] [ [ ]
/
[ 7 ] [ ]
/
8 ] [ [ ]
/
[ 9 ] [ ]
14 GB/IE/NI
to a suitable
[ ]
[
0:00 flashes.
[ ]
/ . The
[ 8 ] [ ]
/
8 ] [ [
goes
[ ]
or
1 ] [
to make settings:
[ ]
Setting
Timer
Swivel function
Operating mode
Increase value
Standby/operation
Decrease value
˜ Selecting an operating mode
Switching the mode: Repeatedly press
/ until the desired operating mode
[ 5 ] [ ]
indicator
[
Display Operating mode
]
.
]
NOTES:
Whether heating level
appropriate selection, depends on the room
size. We recommend first operating the
product on heating level
level if the heat output on heating level
not sufficient.
The operating mode is memorized when the
product is switched to standby mode. When
the product is switched on again, the previous
operating mode will be recalled.
is shown in the display
]
Automatic heating level
The product automatically adjusts
the heating level to the ambient
temperature.
Full heating level
100 % heating power
Half heating level
50 % heating power
Fan
In fan mode, no heating level is
activated.
Frost protection
At room temperature under
+6 °C, the product turns on
automatically.
The product heats the room
until the temperature exceeds
+12 °C.
At a temperature of +12 °C, the
product turns off automatically.
or is the
.. Switch to heating
:
6 ] [
is