Gastroback Design Kaffeemühle Advanced Bedienungsanleitung Seite 29

1. Unplug the appliance from the power outlet before cleaning.
2. Remove Bean Container by turning counterclockwise to ›OFF‹, then lift straight up.
3. Remove the Ground Coffee Container by pulling out from the left-hand side of the
Coffee Grinder.
4. The Removable Ground Coffee Container, Bean Container and Lid should be washed
in warm soapy water, rinsed and dried thoroughly.
5. Polish with a soft, dry cloth. Do not use abrasives. When the units are dry assemble
the appliance for storage or usage.
CLEANING THE MOTOR HOUSING
WARNING: Do not
washer or pour boiling water over it. Do not immerse the motor or power cord in any
liquids or spill any liquids on it or place the motor on wet surfaces. Always wipe off spil-
led liquids immediately. When liquids are spilled on the motor housing, immediately
unplug the appliance and dry the motor housing to avoid risk of electric shock or fire.
Do not attempt to operate the appliance, when liquids are on or in the motor housing.
1. Always turn the appliance OFF ›O‹, wait for the motor to stop completely, and unplug
the appliance from the power outlet before you start cleaning the motor housing.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not to
spill or drip water or any other liquids on the motor housing.
ATTENTION: Ensure not to damage the Grinding Gear. Never poke with anything into
the motor housing. If necessary use a soft brush for cleaning. If any liquids run into the
motor housing clean and dry the motor housing very carefully.
3. Thoroughly dry the motor housing after each cleaning or leave it dry naturally where
it is out of reach of young children. Polish with a soft, dry cloth. Afterwards assemble
the appliance.
to place it in the cavity).
Attendance: You do not need to oil the motor. Clean the units only as described in
the instructions.
WARNING:
Return the entire appliance (including all parts and accessories) to an
authorised service centre for examination and repair.
place the appliance or any parts of it in an automatic dish-
4. You can take out the outer ring of the Grinding Gear for clea-
ning. Use a small soft brush for cleaning it. Do not use water for
cleaning. Water can damage the Grinding Gear or the units might
rust. Watch the cannelure when assembling the Grinding Gear.
Ensure the outer ring of the Grinding Gear is lockered into position
and properly assembled (you might have to turn the unti a little bit
29