Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Getting Started
Attention! Before first use, it is recommended to fully charge
the internal battery using the USB cable (see diagram). This
may take several hours. You can check the charge level in the
status bar when you turn on the device (
Before first use, the battery
y
according to the diagram in the figure.
(11)
into the battery compartment (14).
Install the battery
y
A pictogram in the form of a "dot" on the battery should be
on the left. You will hear a click when the battery is placed
correctly.
Open the lens covers (2).
y
Press the ON/OFF button
y
on.
Adjust the interpupillary distance by moving the eyepieces
y
(13)
farther or closer to each other. It takes some effort to
move the eyepieces.
Adjust the symbol sharpness on the displays by rotating
y
the eyepiece dioptre rings (12). In future, it will not be
necessary to rotate the eyepiece dioptre rings, regardless
of the distance and other conditions.
y
To focus on the object being observed rotate the lens
focusing ring (10).
Select the calibration mode: manual (M), semi-automatic
y
(SA) or automatic (A) in the main menu (enter the menu by
long pressing the MENU button (9).
Calibrate the image with a short press of the ON/OFF
y
(4)
(when calibration mode (SA) or (M) has been
button
selected). Close the lens cap before manual calibration.
).
(11)
should be charged
(4)
briefly to power the device
Select the required amplification level ("Normal", "High",
y
"Ultra") by briefly pressing the DOWN button (8).
Activate the smoothing filter
y
improve the thermal image as the amplification level
increases.
Select one of the colour palettes in the main menu (for
y
more details, see the Interface –> Main Menu –> Colour
Modes section of the full version of the manual).
Adjust the brightness, display contrast, smooth digital
y
zoom in the quick menu (activate by briefly pressing the
MENU button (9).
Briefly press the LRF button
y
The rangefinder reticle will appear in the centre of the
image. Press and hold down the LRF button
seconds to measure the distance in scan mode. If the
rangefinder is idle longer than for 4 seconds, it turns off
automatically.
After use, press and hold down the ON/OFF button
y
turn the device off.
Recommended: When using the device for the first time, it
is recommended to connect to the Stream Vision 2 App and
check for firmware updates. If a newer version is available,
you should update the firmware.
in the main menu to
(6)
to measure the distance.
(6)
for 2
(4)
to
English
13
Werbung
