Dmx Operation - EuroLite LED SL-1000 MZF DMX Search Light Bedienungsanleitung

Manual control
1 Connect the control panel to the device via the 5-pin DMX cable. Select starting address 001 in menu
item Fixture Address.
2 Turn on the LED with the LAMP ON/OFF button.
3 Dimmer fader, to adjust the brightness.
4 Strobe fader, three functions: up to 50% of the fader path controls strobe speed, from 51% of the fader
is pulse effect and from 76% is random strobe.
5 CTO fader, to correct the color temperature.
6 Iris fader, to adjust the diameter of the light beam.
7 Focus fader, to sharpen or soften the edge of the light beam.
8 Zoom fader, to focus or widen the light beam.
9 Color buttons, to directly select one of 7 colors. This will rotate the built-in color wheel to the
corresponding position. Half colors can be created by pressing the desired adjoining color buttons
simultaneously (except for white and purple).
10 Diffusion button, to soften the light beam.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
Master/Slave is indicated on the display and choose the Slave setting. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Now configure the master unit. Select the Master setting in the Master/Slave menu and confirm with the
ENTER button.
4 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.

DMX operation

Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 8 control channels. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button until the display shows Fixture Address. Confirm with the ENTER button.
2 Now the display indicates the menu item for the DMX starting address. Use the buttons UP and DOWN
to set the desired address. Confirm with the ENTER button.
3 The display lights continuously when DMX signals are being received. If no control signals are available,
the display will flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronously.
24/28 00152505.DOCX, Version 1.0