Storage - Silvercrest SFM 850 A1 Bedienungsanleitung

■ Clean the handle
and the fondue ring
Afterwards, rinse all the parts off using clean water.
■ Clean the housing and the frying container
use a mild washing-up liquid on the cloth. Afterwards, wipe clean with a
cloth moistened only with water to ensure that no detergent remains in the
frying container
■ Clean the appliance lid in warm water using a mild detergent. Rinse the ap-
pliance lid off with clear water. Dry the appliance lid well and then place it
upright on its side so that any excess water still inside the lid can drain away.
Be aware that the lid must be completely dry before re-use!
■ Clean the permanent metal filter
then rinse it with clear water.
4) Dry all parts well before assembly.
5) Replace the permanent metal filter
cover over the permanent metal filter
6) Replace the lid on the appliance so that the hinges grip into the hinge supports
on the rear side of the appliance and sit firmly in place.

Storage

1) Lift or carry the appliance using the side handles
2) Wrap the power cable around the cable retainer
pliance. Push one of the pins of the mains plug into one of the holes on the
cable retainer
3) Store the appliance with the appliance lid closed. This will keep the inside of
the deep fat fryer clean and free of dust.
│
■ 38 GB
, the permanent metal filter
in warm water with a little mild washing-up liquid.
. Dry the housing and the frying container
in warm water with a little detergent,
in the cavity in the device lid and close
to hold the mains plug in place:
, the fondue skewers
with a damp cloth. If required,
.
on the housing.
on the rear of the ap-
SFM 850 A1
thoroughly.