Exsys EX-1452IS Bedienungsanleitung Seite 12

English
4. Hardware Installation
Because there are large differences between PC's, we can give you only a general
installation guide. Please refer your computer's reference manual whenever in doubt.
1. Use precautionary measures to discharge static electricity! Before installation,
remove possible static discharge potentials from all objects with which the insulator
could come into contact. This can be done, for example, by touching a bare metal
housing rail after switching off the power supply.
2. Now connect the EX-1452IS with the included USB cable and the other end of the
cable to the USB port on your PC.
3. Now connect the devices to the EX-1452IS.
4. If desired, now install the wall mounting kit or the optionally available DIN-Rail Kit on
the EX-1452IS.
5. Driver Installation
All Operating Systems
After the hardware installation the OS will recognize the device automatically and install
the drivers.
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at „USB-Controller" the following
new entry's:
If you see this or a similar information the device is installed correctly.
© Copyright 2020 by EXSYS Vertriebs GmbH. All Rights Reserved
12
EX-1452IS