VEKA INT
d
• Elektriniai šildytuvai papildomo aptarnavimo
nereikalauja. Būtina tik laiku keisti oro fi ltrą,
kaip nurodyta auksčiau.
• Šildytuvai turi 2 šilumines apsaugas: automa-
tiškai atsistatančią, kuri suveikia prie +50 ºC;
ir rankiniu būdu atsatomą, kuri suveikia prie
+100 ºC.
• Suveikus rankiniu būdu atstatomai apsaugai
reikia atjungti įrengini nuo maitinimo šaltinio.
Palaukti kol atvės kaitinimo elementai ir nu-
stos suktis venatiliatorius. Nustačius gedimo
priežastį, reikia ją pašalinti. Paspausti "reset"
mygtuką ir paleisti įrenginį.
• Esant būtinybei elektrinį šildytuvą galima iš-
imti. Reikia atjungti elektrinę jungtį nuo šildy-
tuvo ir šildytuvą ištraukti (pav. 10).
Pav. 10
Рис. 10
Pic. 10
Bild 10
a
d
14
e
• Электрический нагреватель не требует допол-
нительного обслуживания. Только необходимо
вовремя менять воздушный фильтр, как ука-
зано выше.
• Нагреватель имеет 2 тепловые защиты: авто-
матического восстановления, которая сраба-
тывает при +50 ºС , и ручного восстановления,
которая срабатывает при 100 ºС.
• Если срабатывает защита ручного восста-
новления, необходимо отключить устройство
от источника питания. Подождать, пока не
остынут нагревательные элементы и не пере-
станет крутиться вентилятор. После установ-
ления причины неисправности необходимо
устранить ее. Нажать кнопку reset и запустить
устройство.
• В случае необходимости электрический нагре-
ватель можно вынуть. Надо отключить элек-
трический разъем от нагревателя и вытащить
нагреватель (рис. 10).
b
e
f
• Electrical heaters do not require additional
servicing. Change the air fi lter in time, as de-
scribed above.
• The heater has 2 thermal protections: auto-
matic restore which is activated at +50°C and
manual restore which is activated at +100°C.
• If the manual restore protection is activated,
disconnect the unit from the power supply
source. Wait until the heating elements cool
down and the fan rotation stops. Press the
Reset button and start the unit.
• The electric heater can be removed if neces-
sary. Disconnect the electric connector from
the heater and pull out the heater (Pic. 10).
c
• Das Elektro-Heizregister bedarf keiner zusätzli-
chen Wartung. Es ist nur der Luftfi lter rechtzei-
tig zu wechseln, wie oben aufgeführt.
• Das Heizregister verfügt über 2 Wärmeschutz-
vorrichtungen: die mit einer automatischen
Rückstellung, die bei +50 ºC anspricht; die mit
einer manuellen Rückstellung, die bei +100 ºC
anspricht.
• Bei Ansprechen der Schutzvorrichtung mit ma-
nueller Rückstellung ist das Gerät vom Strom-
netz zu trennen. Abwarten, bis die Heizkörper
sich abgekühlt haben und der Ventilator zum
Stillstand gekommen ist. Störungsursache fi n-
den und beseitigen. Auf Taste „reset" drücken
und das Gerät erneut starten.
• Bei Bedarf kann das Elektro-Heizregister he-
rausgenommen werden. Dazu den Stroman-
schluss am Heizregister trennen und das Heiz-
register herausziehen (Abb. 10).
www.salda.lt