Interruption Of The Descaling Cycle; Meaning Of Light Signals - Philips HD8829 Gebrauchsanweisung

English
26

Interruption of the descaling cycle

Meaning of light signals

13 The machine is heating up and performs an automatic rinsing cycle. The
ESPRESSO and COFFEE buttons flash simultaneously. The descaling
cycle is finished.
Caution: If the no water lights up continuously and the rinse cycle light
does not go out, the water tank was not filled up to the MAX level for the
rinsing cycle.Fill the water tank with fresh water and repeat the process
from step 10.
14 Remove the drip tray, rinse it and place it back. Empty the container.
15 Reinstall the Intenza+ water filter (if present).
16 Remove the water tank and rinse it.
17 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
The machine is ready for use.
Once the descaling procedure has started, complete it until the very end
without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the ON/OFF button.
If this occurs, or in case of a power failure or accidental disconnection of the
cord, do the following:
1 Remove the water tank rinse it and fill it with fresh water up to the MAX
level.
2 Make sure the main switch is set to the ON position.
3 Press the ON/OFF button to switch on the machine.
4 Wait until the ESPRESSO, COFFEE and HOT WATER/MILK CLEAN
buttons light up continuously.
5 Empty the drip tray and place it back.
6 Empty the container and place it back.
7 Press the HOT WATER/MILK CLEAN button once to dispense 0.5 l of
water. Press the same button to stop the water dispensing.
-
The HOT WATER/MILK CLEAN button flashes.
8 Empty the container.
9 Place the container under the coffee dispensing spout.
10 Press the COFFEE button.
11 Repeat steps 9-10.
12 Empty the container.
The machine is ready for use.
- The ESPRESSO and COFFEE buttons flash. The machine is warming up
or performing an automatic rinsing cycle.