Measuring The Water Hardness; Installing The Intenza+ Water Filter - Philips HD8829 Gebrauchsanweisung

English
12

Measuring the water hardness

1 2
3
4
numbers of red squares
1/2
3
4

Installing the Intenza+ water filter

8 Fill the water tank with fresh water up to the MAX indication
The machine is ready for use.
Note: The automatic rinsing cycle starts when the machine has been in
stand-by mode, or switched off , for more than 30 minutes. When you
have not used the machine for 2 or more weeks, you will need to perform
a manual rinse cycle.
To be able to adjust the machine settings to the water in your region, please
measure the water hardness with the water hardness strip supplied.
1 Immerse the water hardness test strip (supplied with the machine) in
fresh water for 1 second.
2 Remove the water hardness strip and and wait for 1 minute.
3 Check how many squares have changed into the red color and check the
water hardness in below table.
value to be set
A
B
C
We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter 'Guarantee and support', section 'Ordering
maintenance products'.
Note: Replace the INTENZA+ filter after 2 months.
1 Remove the small white filter from the water tank and store it in a dry
place.
Note: Please keep the small white filter for future use. You will need it for
the descaling process.
water hardness
very soft water/ soft water
hard water
very hard water