Rida ® Quick Scan Ii: Overview - R-Biopharm RIDA QUICK SCAN II Bedienungsanleitung

®
RIDA QUICK SCAN II
The RIDA
with an identical type that is approved by R-Biopharm AG!
No liability can be accepted for damage to the device or its accessories or other
material damage or injury caused by the use of a mains unit other than that which
is supplied or approved by R-Biopharm AG.
In such cases all warranty claims against the manufacturer are void! The same
applies for modifications to the mains unit that are not authorized by
R-Biopharm AG!
Insert the plug connector on the device side of the mains unit into the rear socket of the
®
RIDA QUICK SCAN II marked "6VDC" and connect the mains unit to the mains.
Before using for the first time, the battery of the device must be fully charged with
the mains unit supplied. The device may be used during the charging process.
Note: This does not apply for charging via the USB port of a connected PC. This
does not provide sufficient charging current to enable continuous operation during
the charging process!
®
3 RIDA QUICK SCAN II: Overview
5
®
Fig. 1: RIDA QUICK SCAN II General view
26
|
Version 1.1 Bedienungsanleitung/User manual
®
QUICK SCAN II must only be used with the mains unit supplied or
1
4
3
2
6
1 Housing
2 On switch
3 Status LED
4 Touchscreen Display
5 Drawer for sample holder
6 Sample holder