What To Do If; Installation - Zanussi ZOB463 Benutzerhandbuch

Clean the glass panel with water and soap. Dry the glass
panel carefully.
Installing the door and the glass panel
When you install the panel with a decorative frame, make
sure that the screen-printing zone looks to the inner side
of the door. Make sure that after the installation the sur-
face of the glass panel frame on the screen-printing zones
is not rough when you touch it.
Make sure that you install the internal panel of glass in the
seats correctly (refer to the illustration).

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not operate.
The display shows 12.00
Steam and condensation settle on the
food and in the oven.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

Warning! Refer to "Safety information" chapter.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The fuse in the fuse box is released.
The oven lamp is defective.
There was a power cut.
You left the dish in the oven for too
long.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
Remedy
Activate the appliance.
Set the clock.
Make sure that the settings are cor-
rect.
Do a check of the fuse. If the fuse is
released more than one time, contact
a qualified electrician.
Replace the oven lamp.
Set the clock.
Do not keep the dishes in the oven
for longer than 15-20 minutes after
the cooking ends.
.........................................
.........................................
.........................................
13