Changing The Program After It; Is Started; Canceling The Programme - Grundig GTN 482610 GCH Bedienungsanleitung

When the child lock is active:
The machine runs, or in stand-by
state the indicator symbols
won't change upon changing the
position of the program selection
button.
6.13 Changing the program after
it is started
You can change the program you
selected to dry your laundry with a
different program after the machine
starts running.
• For example, to select Extra Dry
instead of Iron Dry, pause the
program by pressing the Start /
Stand-by button.
• Select the Extra Dry program
using the Program Selection
button.
• Press the Start/Stand-by button
to start the program.
Adding and removing clothes
during stand-by
If you want to add or remove clothes
to/from the machine after the drying
program starts:
• Press the Start/Stand-by button
to put the machine in Stand-by
state. The drying operation stops.
• Open the loading door while in
Stand-by state, and close the
door after you remove or add
laundry.
• Press the Start/Stand-by button
to start the program.
C
Adding laundry after the
drying operation starts may
cause the dried laundry
inside the machine to mix
with wet laundry and leave
the laundry damp at the
end of operation.
72
C
Adding or removing laundry
during drying may be
repeated as many times as
you wish. But this operation
continuously interrupts the
drying operation, and thus
increases program duration
and energy consumption.
So, it is recommended to
add laundry before the
program starts.
C
If a new program is
selected by turning the
program selection knob
while the machine is in
stand-by; the running
program terminates and
new program information is
displayed on the screen.
WARNING: Do not touch the
inner surface of the drum
while adding or removing
clothes during a continuing
program. The drum surface
is hot.
6.14 Cancelling the program
If you want to cancel the program and
terminate the drying operation for
any reason after the machine starts
running, keep the On/Off/Cancel
button pressed for 3 seconds.
A
WARNING: The inside of the
machine shall be extremely
hot when you cancel the
program during machine
operation, so run the
ventilation program to allow
it to cool down.