Battery Charging And Care - Drive PowerStroll Bedienungsanleitung

EN
Operating the PowerStroll
• Direction. Press the power button, the light of for-
ward button illuminates to indicate the direction of
going forward. Press the backward button and its
light will illuminate to indicate the PowerStroll will
go backward.
• Lift-up strap. The PowerStroll comes with a lift-
up strap to allow the wheelchair to move when
there is no power. Lift up the PowerStroll with the
red strap and hook the second loop around the
push handle. Please note that failure to lift up the
PowerStroll when reversing may cause the pack
to flip over.
• Maximum Speed. Always set a maximum
speed which you are comfortable walking with.
• Pushing the Wheelchair When Not In Use. We re-
commend that the powerpack is restrained with
the lift-up strap when not in use.
Handle Set Operation
Please note there is a 2 - second delay when
starting up the PowerStroll before the wheel will
move. Wait 2 seconds before squeezing the trigger.
• Trigger – Squeeze the trigger to propel the Power-
Stroll. The more the trigger is squeezed, the faster
the PowerStroll will travel. Release the trigger to
stop the PowerStroll.
• Controller (Figure 2) – Press the Speed button to
increase (3) or reduce (2) the speed of the Power-
Stroll. Press the direction button to move forward
(5) or reverse (6) the PowerStroll.
• Inner Knob – This is used to determine the angle of
the handle set.
1
1
Figure 1: 1. Controller, 2. Inner Knob, 3. Trigger.
Figure 2: 1. Power Button, 2. & 3. Speed Adjust Buttons,
4. Battery Indicator, 5. Foward Button, 6. Reverse Button
12
2
4
3
5
2
2 6 1
Disassembly and Transportation
1. Switch the PowerStroll off at the Power Button.
2. Disconnect / unclip the powerpack connector
from underneath the handset.
3. Remove the lift-up strap from the push handle.
4. Lift the battery pack out of the battery tray by using
the handle of the battery and then by pressing the
PUSH button on the powerpack.
5. Remove the powerpack by pulling the Velcro strap
whilst pulling the powerpack from the rear of the
brackets (see the photo below).
6. Place all items in the carry holdall supplied.
Notes:
• The battery supplied with the PowerStroll is classi-
fied as safe for air travel by compliance with IATA
special provision A67.
• The battery pack and power pack have fabric
handles to make them easier to carry.

Battery Charging and Care

Follow the procedure below step by step:
1. Turn the power switch to (OFF)
2. Lift out the battery pack using the handle on the
pack.
3. Plug the charger's power cord into the mains.
4. Plug the charger's round plug into the charging
socket of the battery pack
5. Switch on the plug socket.
6. The charger's LED will illuminate orange to indica-
te the batteries are charging. The charging dura-
2
tion is about 8 hours. To ensure optimum perfor-
mance a 12-hour charge is recommended.
7. The orange LED will turn green when charging is
complete.
8. Turn off the charger, disconnect the power cord
and the round plug from the battery pack.