Dmx Operation; Dmx-Protocol - EuroLite LED FL-1500 Bedienungsanleitung

DMX Operation

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED FL-1500 Flamelight with DMX will respond to the controller.
Every DMX channel has a different occupation with different features.
Addressing
Press the MODE button until the display shows ADDR and press the ENTER button.
Set the desired address (between 001 und 512) via the UP or DOWN buttons.
Press ENTER in order to confirm
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Choosing a DMX Channel Mode (2 optional modes)
After having set the desired address(es) and pressed ENTER, you can now choose a DMX Channel Mode.
Press the MODE button until the display shows CHND and press the ENTER button.
Via the UP or DOWN buttons, you can choose between the DMX modes "3 CH and 6 CH".
Please see the following DMX protocol graphics for the respective channel values.

DMX-Protocol

3-Channel mode:
Channel DMX-Value
1 000-255
2
000-255
3
000-255
6-Channel mode:
Channel DMX-Value
1 000-255
2
000-255
3 000-255
000-015
4
016-255
000-015
5
016-255
6
000-255
Note: In order to change from DMX-controlled operation back to stand-alone operation, please disconnect
Function
Red (0 - 100 %)
Green (0 - 100 %)
Blue (0 - 100 %)
Function
Red (0 - 100 %)
Green (0 - 100 %)
Blue (0 - 100 %)
No function
Auto program, increasing speed (0 - 100 %)
No function
Strobe, increasing speed (0 - 100 %)
Dimmer (0 - 100 %)
the device from the DMX-controller.
17/18 00092593, Version 1.1