Troubleshooting - Texas A/S SNOWBUSTER 1100E Bedienungsanleitung

TROUBLESHOOTING

Fault
The unit does not operate
smoothly and vibrates
intensively
Engine does not run
Engine does not run smoothly
Drive power falls
The engine will not start or dies
after a short period of time
Inadequate or no ejection
The snow is not removed fully
Turn off the engine and pull out the ignition cable before
making any inspection or adjustments.
If after making an adjustment or repair to the engine, and
you let it run for a few minutes, remember that the
exhaust and other parts will get hot.
Do not touch these parts as these may burn you.
Possible causes
Bolts loose
Auger unit mounting loose
Throttle lever in wrong
position
Spark plug defective
Fuel tank empty
Fuel cock closed
Bad Fuel
Spark plug dirty
Clutch play too large
Drive Belt loose or
damaged
Choke in wrong position
Spark plug Fouled
No fuel
Snow ejection until
blocked
Plow screw not turning
Shearing bolts sheared
Skids maladjusted
WARNING
Check bolts
Check auger unit mounting
Check setting
Replace spark plug
Top up fuel
Open fuel cock
Empty Fuel Tank and refill with
Fresh Fuel
Clean the spark plug
Adjust clutch cable
Replace Drive Belt
Contact authorized customer
service
Check Choke setting
Clean or replace spark plug
(electrode spacing 0.6mm)
Top up fuel
Clean the snow ejection unit with a
solid object
Adjust Auger clutch cable
Replace shear bolts or contact
authorized customer service
Adjust the skids
40
Remedy