Texas A/S SNOWBUSTER 1100E Bedienungsanleitung Seite 28

Gear control
1. Insert gear knob through the control panel
Attach and fit gear rod onto the gear knob and crank fasten when adjusted.
2. Pull split and attach the other end of the gear rod crank onto the transmission axle
3. Re-adjust by tighen the nut to put tension on the gear
Chute discharger
Follow the instruction below
Once the chute discharger is assembled, it should be free to move by hand. If not please recheck
whether the plates are in the correct sequence and that the bolts are not over-tightened.
If the chute control knob is over-turned. The teeth might slip and thereby jam the chute assembly. In
such case please loosen the support plates and readjust teeth and plates.
28