Before Use; Charging The Battery Pack (See Fig . A); Attaching/Disconnecting The Battery Pack To/From The Appliance; Operation - Parkside Pak 20-Li C3 Originalbetriebsanleitung

Before use:

Charging the battery pack (see fig . A)

CAUTION!
► Always unplug the charger before you
remove the battery pack
to the charger .
NOTE
► The battery is partially charged . Ideally,
charge the battery completely before use .
This guarantees full battery performance .
Li-ion batteries can be charged at any time
without adversely affecting their service life .
Interruption of the charging process will not
damage the battery .
► Never charge the battery pack
the ambient temperature is below 10°C or
above 40°C . If a lithium-ion battery is to be
stored for an extended period, the charge lev-
el should be checked regularly . The optimum
charge level is between 50% and 80% . The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C .
♦ Insert the battery pack
charger .
♦ Insert the mains plug into the mains socket . The
control LED lights up red to indicate that the
appliance is charging .
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready .
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
PAK 20-Li C3
from or connect it
when
into the high-speed
into the appliance .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the battery pack
clicks into place .
Removing the battery pack:
♦ Press the release button
battery pack .
Checking the battery charge level:
♦ Press the battery charge level button
check the charge level of the battery . The
status/remaining charge will be shown on the
battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Operation

This appliance is not designed for continuous oper-
ation . The appliance may be used for a maximum
of 10 minutes of continuous operation . If the appli-
ance overheats, remove the battery pack
the appliance to cool down completely and then
try using it again .

Display

♦ Press the ON/OFF switch
or press the ON/OFF switch
the display indicator
♦ The last set pressure is displayed for 2 seconds .
♦ After two seconds, the current pressure of the
connected item is shown .
NOTE
► If the compressed air hose is not connected
to a suitable item, the display indicator
shows "0" .
♦ If the display indicator
can switch between "bar" and "psi" by pressing
the ON/OFF button
into the handle until it
and remove the
to
as follows:
. Allow
on the display
to switch on
.
is switched on, you
.
GB │ IE │ 7 ■