Engine Lubrication - Ransomes HR3300T Sicherheits-, Betriebs- Und Wartungshandbuch

8 MAINTENANCE &
LUBRICATION
8.2

ENGINE LUBRICATION

Check Engine Oil Level
Check the engine oil level before starting or more
than five minutes after stopping the engine.
(a) With the machine on level ground, remove the
dipstick D, wipe it clean and replace.
(b) Take the dipstick D out again, and check the
oil level. It should be between level marks (E)
on dipstick.
Change Engine Oil.
(a) Warm up the engine first and then shut it off.
Remove oil drain plug (A) from the bottom of
the crankcase and wipe it off.
(b) Drain engine oil in to a suitable container.
(c) Replace the drain plug (A) and fill engine with
the correct quantity & grade of oil through one
of the fillers (B).
Change Engine Oil Filter
(a) Remove single-unit cartridge (C)
(b) Collect engine oil in a suitable container.
(c) Clean area on crankcase.
(d) Apply thin coat of oil to cartridge gasket before
installing.
(e) Tighten filter by hand only.
(f) Check for oil leaks around the cartridge gasket
after engine is started.
Contact with engine oil can damage your skin.
Use gloves when working with engine oil. If you
come in contact with engine oil, wash it off
immediately.
Dispose of used engine oil in accordance with
local regulations
en-46
SAFETY, OPERATORS & MAINTENANCE MANUAL
D
B
C
A