Hydraulic Test Ports - Ransomes HR3300T Sicherheits-, Betriebs- Und Wartungshandbuch

8 MAINTENANCE &
LUBRICATION
8.6 HYDRAULIC SYSTEM FLUSHING
When changing from mineral to vegetables oil
Terresolve ™ EnviroLogic ® BioFlush is a carefully
designed fluid which helps to flush and remove
petroleum oil from hydraulic systems. This is done
when converting hydraulic systems to the use of
biodegradable fluids.
EnviroLogic ® BioFlush will condition the internal
hydraulic system to help optimize both overall system
performance and fluid biodegradability.
1. Run equipment until warm. Drain petroleum
hydraulic fluid and replace all hydraulic filters.
2. Fill system with EnviroLogic. BioFlush. Run
equipment for 5 minutes until fluid is
completely circulated.
3. Drain the BioFlush and replace hydraulic
filters.
4. Fill system with approved biodegradable ISO
VG 46 hydraulic oil.
The hydraulic system is now optimized for fluid
biodegradability in the event of leakage.
8.7

HYDRAULIC TEST PORTS

If any problems are experienced with the hydraulic
system service ports are provided to enable
pressures to be checked.
All tests, unless stated otherwise, should be carried
out with the hydraulic oil at normal working
temperature.
TEST PORTS
A. Transmission pressure: 250 bar forward /
reverse.
B. Deck drive pressure: 250 bar.
C. Steering and lift pressure 125 bar.
NOTE: Any servicing of the hydraulic system must
be carried out by trained service personnel.
en-50
SAFETY, OPERATORS & MAINTENANCE MANUAL
When changing from vegetables to mineral oil
There is no need to flush the system.
Contact with hydraulic oil can
damage your skin. Use gloves when
working with hydraulic oil. If you
come in contact with hydraulic oil,
Dispose of used hydraulic oil
in accordance with local regulations
C
wash it off immediately.
B
A