LGB Mogul Bedienungsanleitung Seite 5

Smoke and Cleaning Fluid is included
with this model. For best operation,
fill the generator halfway with fluid. If
the generator is overfilled, it will not
convert the fluid into smoke.
Attention! Never touch the heating
element in the center of the smoke
generator. It is hot and fragile. Not
for children. Only for use by adults!
Attention! Only use LGB Smoke and
Cleaning Fluid (50010). Other fluids
may damage your locomotive.
Hint: The smoke generator can be
run "dry" without smoke fluid.
Power Supply
Attention! For safety and reliability,
operate this model with LGB power
supplies (transformers, power packs
and controls) only. The use of non-
LGB power supplies will void your
warranty.
Use this model with LGB power sup-
plies with an output of at least 1
amp. For more information on LGB
power supplies for indoor, outdoor
and multi-train operation, see the
LGB catalog.
Sound
To equip this model with sound, we
recommend the following products:
- 65001 American Steam Sound Unit
- 65011 Sound Unit Power Storage
The 65011 is not needed when oper-
ating with the LGB Multi-Train
System.
If there is not enough space inside
the locomotive or if you prefer not to
disassemble the loco, you can place
the Sound Unit in a freight or pas-
senger car and connect it to the loco-
motive via the multi-purpose socket.
Multi-Train System
The model is equipped with a DCC
interface to connect a decoder (Fig.
10
5). Remove the plug on the decoder
interface and connect the decoder.
We recommend the 55027 MTS
Loco Decoder III. Its plug fits direct-
ly onto the socket of the interface.
Hints:
- We recommend decoder installa-
tion by an LGB service station. For
more information, contact your
authorized LGB retailer or an LGB
service station (see Authorized
Service).
- The plug of the decoder fits only in
one direction onto the pins on the
loco circuit board.
- If the decoder is removed, the orig-
inal plug must be replaced on the
DCC interface. Otherwise, the loco
will not work.
- The power control switch does not
work when a decoder is installed.
Attention! After extended operation,
this model may leave carbon dust or
other debris around the track. This
dust and debris can stain carpet and
other materials. Consider this when
setting up your layout. Ernst Paul
Lehmann Patentwerk and LGB of
America are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will void
your warranty. For quality service,
contact your authorized retailer or an
LGB factory service station (see
Authorized Service).
Hint: Additional expert instructions
for many LGB products are available
at www.lgb.com.
Lubrication
The axle bearings and the side rod
ends should be lubricated occasion-
ally with a small amount of LGB
Maintenance Oil (50019).
Cleaning
This model can be cleaned externally
using a mild detergent and gentle
stream of water. Do not immerse this
model.
Replacing the light bulbs
Front lantern: Pull the lantern hous-
ing away from the model. Pull the
socket out of the housing. Pull the
plug-in bulb out of the socket. Plug
in a new bulb. Reassemble.
Replacing the smoke generator
- Pull the safety cover out of the
smoke stack (Fig. 6).
- Use pliers or tweezers to pull the
old smoke generator out of the
stack (Fig. 7).
- Cut the wires to the old generator
and attach them to the replace-
ment generator (Fig. 8).
- Insulate the connections and push
the replacement generator into the
stack.
- Reassemble.
Replacing the traction tire
- Remove the hex screw on the drive
wheel with the traction tire.
- Remove the side rods.
- Use a small, straight-blade screw-
driver to replace the traction tire:
- Pry the old traction tire out of the
wheel groove.
- Gently insert the new traction tire
into the wheel groove.
- Make sure that the traction tire is
seated properly in the wheel groove.
- Reassemble.
Maintenance parts
LGB 50010 Smoke and Cleaning
Fluid
LGB 50019 Maintenance Oil
LGB 51020 Gear Lubricant
LGB 55027 MTS Decoder III
LGB 62204 Standard Motor with
Long Shaft
LGB 63120 Brushes, Assembled,
14 mm and 16 mm,
8 pieces
LGB 63218 Standard Pick-Up
Shoes, 2 pieces
LGB 65853 Smoke Generator, 5V
LGB 68511 Plug-In Bulb, Clear,
5V, 10 pieces
LGB 69184 Traction Tire, 46.5 mm,
10 pieces
AUTHORIZED SERVICE
Improper service will void your war-
ranty. For quality service, contact
your authorized retailer or one of the
following LGB factory service sta-
tions:
Ernst Paul Lehmann Patentwerk
Reparatur-Abteilung
Saganer Strasse 1-5
D-90475 Nürnberg
GERMANY
Telephone: (0911) 83707 0
Fax: (0911) 83707 70
LGB of America
Repair Department
6444 Nancy Ridge Drive
San Diego, CA 92121
USA
Telephone: (858) 795-0700
Fax: (858) 795-0780
You are responsible for any shipping
costs, insurance and customs fees.
Hint: Information on LGB products
and LGB representatives around the
world is available online
www.lgb.com
at
11