Towing / Trailering; 5.10 Hillside Operation - Jacobsen 68098 Handbuch

5.9

TOWING / TRAILERING _____________________________________________________

If the mower experiences problems and must be shut down and
removed from the area, it should be loaded onto a trailer for
transport. If a trailer is not available, the unit can be towed
slowly for short distances.
Use care when loading and unloading mower. Fasten mower to
trailer to prevent mower from rolling or shifting during transport.
Long Distance Trailering / Transport. If the mower is to
be trailered on the highway, before strapping to trailer, close
fuel shut off valve and inflate tires to maximum pressure
listed on side of tire. Reduce tire pressure to normal after
removing from trailer. [See 5.10].
Before towing, open tow valve. The tow valve permits moving
the mower without starting the engine and prevents possible
damage to hydraulic components.
The tow valve (A), is located on the hydraulic drive pump
beneath the operators seat. Remove cover from floor in front of
operator's seat. To open valve, use a wrench or insert a pin or
small screw driver into the small hole in the valve stem. Turn the
valve counterclockwise one full turn.
Before towing make sure cutting units are raised. If they cannot
be raised, remove them from the mower.

5.10 HILLSIDE OPERATION _____________________________________________________

!
WARNING
To minimize the possibility of overturning, the safest
method for operating on hills and terraces is to travel up and
down the face of the slope (vertically), not across the face
(horizontally). Avoid unnecessary turns, travel at reduced
speeds, and stay alert for hidden hazards.
!
CAUTION
Do not operate this mower on slopes greater than 20°.
The mower has been designed for good traction and stability
under normal mowing conditions. Use caution when operating
on slopes, especially when the grass is wet. Wet grass reduces
traction and steering control.
1. Always mow with the engine at full throttle, but reduce
forward speed to maintain the proper cutting frequency.
Activate traction control (S) as required to improve weight
2.
distribution between decks and mower. [See 4.3].
Close valve completely and replace cover after towing.
NOTICE
Do not exceed 2 MPH (3.2 KPH) while towing. Long
distance towing is not recommended
A
3. If the mower tends to slide or the tires begin to mark the
turf, angle mower into a less steep grade until traction is
regained or tire marking stops.
4. If mower continues to slide or mark the turf, the grade is too
steep for safe operation. Do not make another attempt to
climb, and back down slowly.
5. When descending a steep slope, always lower
implements to the ground to reduce the risk of mower
overturning.
Correct tire pressure is essential for maximum traction.
Front ......................... 16 psi (111 kPa)
Rear .......................... 12 psi (86 kPa)
OPERATION 5
.
LF006
Figure 5B
en-19