Operating Procedures - Jacobsen 68098 Handbuch

5 OPERATION
5.3

OPERATING PROCEDURES_________________________________________________

A Roll Over Protection Structure (ROPS) is included with this mower. Seat belts must be worn whenever operating a
mower with a ROPS. Always keep seat belt snugly adjusted. DO NOT use seat belts on a mower without a ROPS.
If the mower is overturning, hold onto the steering wheel. Do not attempt to jump out or leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection.
1. Under no circumstances should the engine be started
without the operator seated on the mower. Never start
the engine with operator or bystanders standing behind
a discharge chute.
2. Never run the engine in an enclosed area.
3. Keep hands and feet away from moving parts and cutting
units. If possible, do not make adjustments with the engine
running.
4. Do not operate mower or attachments with loose,
damaged or missing components. Whenever possible
mow when grass is dry.
5. First mow in a test area to become thoroughly familiar
with the operation of the mower and control levers.
6. Study the area to determine the best and safest
operating procedure. Consider the height of the grass,
type of terrain, and condition of the surface. Each
condition will require
precautions.
7. Be aware of mower discharge direction and never
direct discharge of material toward bystanders. Never
allow anyone near the machine while in operation. The
owner/operator is responsible for injuries inflicted to
bystanders and/or damage to their property.
!
CAUTION
Before mowing, pick up all debris such as rocks, toys,
and wire which can be thrown by the machine. Enter a
new area cautiously. Always operate at speeds that
allow you to have complete control of the mower.
en-16
!
WARNING
!
CAUTION
certain adjustments
8. Use discretion when mowing near gravel areas
(roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious
injuries to bystanders and/or damage the equipment.
9. Always turn PTO switch OFF to stop blades when not
mowing.
10. Disengage the drive motors, raise the mowers and
slow down when crossing paths or roadways. Look out
for traffic.
11. Stop and inspect the equipment for damage
immediately after striking an obstruction, or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
Before you clean, adjust, or repair this equipment,
or
always disengage all drives, lower implements to the
ground, engage parking brake, stop engine, and remove
key from ignition switch to prevent injuries.
12. Slow down and use extra care on hillsides. Read
Section 5.10. Use caution when operating near drop
offs.
13. Look behind and down before backing up to be sure the
path is clear. Use care when approaching blind
corners, shrubs, trees or other objects that may
obscure vision.
14. Never use your hands to clean cutting units. Use a
brush to remove grass clippings from blades. Blades
are extremely sharp and can cause serious injuries.
!
WARNING