Starting; Stopping / Parking - Jacobsen 68098 Handbuch

5.4

STARTING________________________________________________________________

NOTICE
IMPORTANT: Do not use starting assist fluids. Use of
such fluids in the air intake system may be potentially
explosive or cause a "Runaway" engine condition and could
result in serious engine damage.
!
WARNING
To prevent injuries, sit in the seat, engage parking brake,
place traction pedal in Neutral, and PTO switch in OFF
position before attempting to start the engine.
Sit in operator's seat, make sure the PTO switch (Q) is OFF
1.
(down) and the parking brake is engaged. Remove feet
from pedals. Always use the seat belt when operating
mowers equipped with a ROPS.
Set throttle lever (T) to half throttle and check that alarm
2.
switch (O) is ON.
Turn ignition switch (V) to ON (
3.
Note: At this time the warning lights (N, Y) on the
instrument panel will come on. Check that lights are
operating.
NOTICE
Do not hold key in "START" position for more than 10
seconds at a time. After 10 seconds the starting circuit will
shut down and must be reset by returning the key to the OFF
position.
5.5

STOPPING / PARKING ______________________________________________________

To stop:
Remove your foot from traction pedal.
automatically brake when the traction pedal returns to
Neutral. Always engage parking brake, shut off engine, and
remove key before leaving operator seat for any reason.
To park the mower under normal conditions:
Disengage the PTO switch (Q) then raise and lock the
1.
implements in the transport position and move away from
the area of operation.
2. Select a flat and level area to park.
a. Release traction pedal to bring the mower to a
complete stop.
b. Disengage all drives, lower implements to the ground,
engage parking brake, reduce throttle to idle, and
allow engine to operate at no load for three to five min-
utes.
) position.
The mower will
Wait until glow plug light goes out, then immediately turn
ignition key to "START" (
engine starts. Allow 30 seconds between start-up
attempts to allow time for engine starter motor to cool.
All warning lights should go off after engine starts.Allow
engine to gradually become warm before operating at high
RPM.
N
O
!
WARNING
1. Read operators manual,
do not allow untrained
operators to use machine.
2. Keep shields in place
and hardware securely
fastened.
3. Before you clean, adjust
or repair this equiptment,
disengage all drives,
engage parking brake
and stop engine.
4. Keep hands, feet and
clothing away from
moving parts.
5. Never carry passengers.
6. Keep bystanders away.
7. Inspect hoses and fabric
covers daily. If worn or
damage, replace with
original quality parts.
8. Do not use on slopes
greater than 22 °.
4131828
TC-O/I
NOTICE
Permanent damage to the turbocharger may occur if the
engine is shut down without allowing the turbocharger
time to cool.
To prevent damage, operate the engine at idle with no
load for 3 to 5 minutes before shutting off engine.
3. Engage parking brake, stop the engine, and always
remove the ignition key.
If an emergency arises and the mower must be parked in the
area of operation, follow the guidelines outlined by the grounds
superintendent. If the mower is parked on an incline, chock or
block the wheels.
OPERATION 5
) position. Release as soon as
Y
Q
V
T
Figure 5A
en-17