What To Do If - IKEA LAGAN ov3 Handbuch

ENGLISH
Inserting the door and the glass panel
When the cleaning procedure is completed,
insert the glass panel and the oven door. To
do so, follow the steps in reverse.
The inner glass panel must be assembled
keeping the decorative frame (screen-print-
ing) turned towards outside of the oven. To
double check you did the above operation in
a proper way simply pass your fingers on the
inner glass surface. If the panel of glass is as-
sembled correctly you should not feel any
roughness.
Insert the internal panel of glass into the right
seats as shown below.

What to do if...

Problem
The oven does not op-
erate
The oven does not op-
erate
The temperature indica-
tor does not come on
The oven lamp is not
working
Possible cause
The required setting have not
been set
The appliance is not correctly
connected and the mains supply
to the oven is not on
The required setting have not
been set
The oven lamp bulb is faulty
Changing the oven lamp and cleaning the
glass cover
Warning! Before you change the oven
lamp (refer to "Product description"),
switch off the appliance and disconnect it from
the electrical supply.
1. Turn the glass cover anti - clockwise and
remove it. Clean the glass cover.
2. If necessary, replace the old oven lamp
with a 15/25 watt, 230V (50Hz), 300 °C
heat resistant oven lamp (Connection type:
E14).
3. Refit the glass cover.
Solution
check if cooking function and tem-
perature are selected
Check if the appliance is correctly
connected and the mains supply
to the oven is on
Select the cooking function and
temperature
Replace the oven lamp bulb
9