Herunterladen Inhalt Inhalt Diese Seite drucken

Software Update By Sd Card - Glomex Discovery S460S Betriebs Und Installationsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 90
9.3 SOFTWARE UPDATE BY SD CARD 
The SD card must be inserted into the relevant slot 
on the control unit side. 
Proceed as follows: 
1. Turn off the decoder, the TV set and make sure 
that the switch on the control unit is set to OFF. 
2. Remove the control unit from the wall­mounting 
bracket (see Fig. 12), open the box by loosen­ 
ing the screws (see Fig. 9). 
3. OPTIONAL  (in  case  of  built­in  installation): 
remove  the  wall­mounting  plate  (see  Fig.  13), 
loosen the screws and remove the built­in con­ 
trol unit. 
4. Insert the SD card into the relevant slot on the 
control  unit  side,  as  indicated  in  Fig.  18, 
respecting the direction (side with manufacturer 
label up) and making sure you have completely 
inserted it. 
5. Turn  on  the  control  unit  (set B key, Fig.  15, to 
ON). The led (C, Fig. 15) turns red. 
6. If the control unit detects the presence of a SD 
card  with  original  GLOMEX  software,  the  led 
turns  orange  and  automatically  starts  the  soft­ 
ware updating procedure. 
7. If the led stays red and the antenna moves, this 
means  that  no  original  GLOMEX  software  has 
been  detected,  or  that  the  SD  card  has  not 
been  inserted  completely.  Turn  off  the  control 
unit and repeat the procedure from step 5. 
NOTE: if the control unit is not immediately turned 
off,  in  a  few  seconds  the  led  will  turn  orange  and 
then  green,  according  to  the  standard  satellite 
searching  procedure;  turn  off  anyway  and  repeat 
the procedure from step 5. 
8. If  the  update  is  correctly  carried  out,  the  led 
turns green. Otherwise, the led turns red and it 
is  necessary  to  turn  off  the  control  unit  and  to 
repeat the procedure from step 5. 
9. Remove  the  SD  card  and  reinstall  the  rear 
cover onto the control unit. 
10. OPTIONAL  (in  case  of  built­in  installation): 
insert the control unit into the wall, reinstall the 
fastening screws and the installation plate. 
WARNING 
In case of repeated failures in the software update 
procedure,  please  contact  the  GLOMEX  Service 
Centre. 
www.glomexmobile.com 
Fig. 18
49
 
DISCOVERY S460S 
 
EXPLORER S460M

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Explorer s460m

Inhaltsverzeichnis