DISCOVERY S460S
EXPLORER S460M
8. Mount the coaxial cable onto the antenna:
make sure that the cable core is correctly
inserted in the central hole of the female con
nector on the antenna (otherwise, there would
be a short circuit and the fuse installed on the
power supply line inside the control unit would
trip);
manually screw in the ring nut of connector F;
once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench;
insert the protection;
make the coaxial cable pass through the pre
viously bored 12 mm hole on the vehicle roof.
Fig. 7
Fig. 8
NOTE: For the connection of the antenna coaxial
cable, it is not necessary to remove the dome!
Central hole of
female connector
Central cable
core
40
9. Insulate with appropriate sealants the holes
drilled in order to prevent the passage of water.
For a correct assembly, respect the installation
direction indicated in Fig. 5.
A different installation from the recommended one
could cause an incorrect operation of the antenna
due to the risk of water penetration into the
radome.
Operations to be carried out inside the vehicle.
1. Determine the correct position for the control
unit:
it must be positioned near the satellite
receiver, as the provided coaxial cable is
1.5 m long;
it must be reached by the power supply
cables coming directly from the battery;
it must be reached by the coaxial cable com
ing from the antenna (5 m long);
2. Open the control unit by loosening the screws
with an appropriate screwdriver.
Fig. 9
www.glomexmobile.com
WARNING