5. Intermittent images for short
periods
6. The equipment does not find
the satellite (the led on the
control unit is red)
7. The equipment does not find
the satellite (the led on the
control unit flashes alter
nately red and orange)
8. The equipment does not find
the satellite (the led on the
control unit is orange and
remains orange also when
moving the vehicle)
9. Disturbed images
10. Confused, incomplete and
obstructed images
11. The decoder blocks
www.glomexmobile.com
the
satellite
signals
obstructed by trees, buildings,
overpasses, mountains
the vehicle is at the boundary
of the coverage area
bad weather conditions
the
satellite
signals
obstructed by trees, buildings,
overpasses,
mountains
attachments installed on the
vehicle roof
the vehicle is outside the
signal coverage area
the vehicle is moving during
the first 60 seconds after start
ing the equipment (for S460M
models)
bad weather conditions
inner failure
the
satellite
signals
obstructed by trees, buildings,
overpasses, mountains
the equipment software is not
up to date
parameters in satellite commu
nication have changed
failure of the receiver
condensate or rain on the
radome, which can disturb the
signal with still vehicle
bad weather conditions
alternating current fluctuations refer to the user manual of the
53
DISCOVERY S460S
EXPLORER S460M
are
move the vehicle to allow an
unobstructed view for the
antenna
go back within the coverage
area; refer to the footprints of
the coverage areas on page
47 in this manual
are
move the vehicle to allow an
unobstructed view for the
or
antenna or correctly position
the antenna on the vehicle roof
go back within the coverage
area; refer to the footprints of
the coverage areas on page
47 in this manual
turn off the equipment for
10 seconds, turn it on again
and make sure that the vehicle
is still or moves in a straight
line during the first 60 seconds
after being started
contact the Service Centre
are
move the vehicle to allow an
unobstructed view for the
antenna
please contact the Service
Centre to ask for the software
update by SD card
please contact the Service
Centre to ask for the software
update by SD card
refer to the user manual of the
receiver for assistance, spare
parts and warranty conditions.
remove
the
deposits from the radome with
a fresh water jet (not under
pressure)
Periodically apply a liquid
detergent suitable for dishes
(no alcoholbased detergent)
to the radome surface and let
dry up
receiver for assistance
condensate