Software Update By Sd Card - Glomex Pandora V8000 Betriebs- Und Installationshandbuch

PANDORA V8000

9.3 SOFTWARE UPDATE BY SD CARD

The SD card must be inserted into the relevant slot
on the control unit side.
Proceed as follows:
1. Turn off the decoder, the TV set and make sure
that the switch on the control unit is set to OFF.
2. Remove the wall-mounting plate (see Fig. 15),
loosen the screws and remove the built-in con-
trol unit.
3. Insert the SD card into the relevant slot on the
control unit side, as indicated in Fig. 24,
respecting the direction (side with manufacturer
label up) and making sure you have completely
inserted it.
4. Turn on the control unit (set B key, Fig. 21, to
ON). The led (C, Fig. 21) turns red.
5. If the control unit detects the presence of a SD
card with original GLOMEX software, the led
turns orange and automatically starts the soft-
ware updating procedure.
6. If the led stays red and the antenna moves, this
means that no original GLOMEX software has
been detected, or that the SD card has not
been inserted completely. Turn off the control
unit and repeat the procedure from step 4.
NOTE: if the control unit is not immediately turned
off, in a few seconds the led will turn orange and
then green, according to the standard satellite
searching procedure; turn off anyway and repeat
the procedure from step 4.
7. If the update is correctly carried out, the led
turns green. Otherwise, the led turns red and it
is necessary to turn off the control unit and to
repeat the procedure from step 4.
8. Remove the SD card, insert the control unit into
the wall, reinstall the fastening screws and the
installation plate.
S
WARNING
In case of repeated failures in the software update
procedure, please contact the GLOMEX Service
Centre.
Fig. 24
58
www.glomex.it