Glomex Discovery S460S Betriebs Und Installationsanleitung Seite 44

3. Connect the coaxial cable of the antenna (pre­
viously installed) to the ANTENNA IN input on
the control unit and the 1.5 m coaxial cable to
the RECEIVER OUT output on the control unit.
Make sure that the cable cores are correctly
inserted in the central holes of the relevant
female connectors on the control unit (other­
wise, there would be a short circuit and the fuse
installed on the power supply line inside the
control unit would trip).
Manually screw in the ring nuts of connectors F.
Once the ring nuts have been manually
screwed in, tighten by ¼ turn by means of a
11 mm wrench;
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
damage, GLOMEX will not be directly liable for the
damage suffered by the receiver.
Power supply
cable
Red
Black
From the
antenna
Fig. 10
4. Connect the power supply cable to the battery:
connect the positive terminal of the vehicle bat­
tery to the red cable and the negative terminal
to the black cable. The power supply line com­
ing from the battery must have cables with a
minimum cross section of 2.5 mm
2
up to 4 m, of 4 mm
WARNING
Do not use power supply from secondary circuits.
This could jeopardize the operation of the equip­
ment.
www.glomexmobile.com
To the receiver
2
with a length
for longer cables.
NOTE: The polarity inversion on the power supply
blows the fuse to prevent any damage to the
antenna.
WARNING
Pay attention not to bend the coaxial cables at a
right angle; the bending angle must always be
higher than 120°.
Fig. 11
NOTE: Do not cut the connectors of the coaxial
cables (the operation would not be guaranteed any
more) and always use the supplied cables, even
with inappropriate dimensions (too long). In case a
longer cable is needed, ask the authorized retailer
for a 10 m coaxial cable, provided on demand. Do
not use different cables, as it would jeopardize the
operation of the equipment.
5. Close the control unit by tightening the screws
in the rear cover.
41
DISCOVERY S460S
EXPLORER S460M