1. In case of use with still vehicle, park the vehicle
in an obstaclefree area.
2. Turn on the receiver and the TV set. For details
about the use of the receiver and the TV set,
please refer to the relevant user manuals pro
vided by the manufacturers.
3. On the control unit, by means of the relevant
selector (A), select the desired satellite (ASTRA
1, ASTRA 2, HOTBIRD).
4. Turn on the control unit (set (B) key to ON).
5. After a few seconds, the led (C) turns red, and
this means that the antenna is searching for the
signal.
6. If the antenna has found a signal, the led turns
orange: it checks that the found satellite is the
selected one.
7. If the led, after a few seconds, turns green, this
means that the satellite found was the correct
one. Otherwise, the led turns red again, and the
procedure is restarted.
8. With green led, after a few moments, the image
will appear on the TV set. Follow the instruc
tions appearing on the screen to set the param
eters for a correct operation of the receiver.
WARNING
If the led flashes alternately red and green, this
means that the antenna is not connected or that a
failure has occurred. See section "Troubleshooting"
or contact the Service Centre.
www.glomexmobile.com
Fig. 15
A. Satellite selector
B. Power on key
C. Led
45
DISCOVERY S460S
EXPLORER S460M