Kesser K-CFH-2022 Bedienungsanleitung Seite 4

• Do not connect the appliance to the mains source until it has been installed in its final
location and adjusted to the position it will be used in.
• This appliance is not intended for use in bathrooms, laundry or similar locations which may
be exposed to water, moisture or humidity.
• Always operate on a flat horizontal surface.
• Switch off the appliance, then use handles (where provided) to change its position.
• Do not operate with the cord coiled up as this could cause a build-up of heat, which could
pose a hazard.
• The use of an extension cord with this appliance is not recommended.
• Do not remove the power plug from the socket by pulling the cord – grip the plug instead.
• Always unplug appliance when not in use.
• Do not allow cord to meet heated surfaces during operation.
• Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away from areas
where it is likely to be tripped over.
• Do not twist, kink, or wrap the cord around the appliance, as this may cause the insulation
to weaken and split. Always ensure that the cord has been fully removed from any cord
storage area before use.
• Do not store appliance in a box or closed space until it has cooled down sufficiently.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Young children should be supervised to ensure they do not play with the appliance.
• The appliance must not be located immediately below a socket-outlet.
• Do not use this appliance with a programmer, timer or any other device that switches the
heater on automatically, since a fire risk exists if the appliance is covered or positioned
incorrectly.
• If the supply cord is damaged, it must be replaced by a qualified electrical person to avoid
a hazard.
• Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on the
appliance.
• To avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must
not be supplied through an external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the utility.
ASSEMBLY INSTRUCTIONS
1. Pass the power cord through the central gate and firmly clamp the left base with the right
base, then coordinate the position of body with that position of the base , and fix the screws
of the base with a screwdriver
2. Pass the power cord through the gap of the base.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
4
www.eshopping.de