Setting The Limit Value For Brightness; Switching The Brightness-Dependent Control System On And Off - Superrollo GW70 Gebrauchsanleitung

After approx. 20 minutes, the device checks the
brightness again. To do this, the roller shutter is
automatically raised until the sun sensor is no longer
covered by the roller shutter's shadow.
When the brightness at the sun sensor falls below the
set limit value, the roller shutter moves up to the upper
limit stop. In the event of changing weather conditions,
the 10 or 20 minute periods of time may be exceeded.
The brightness-dependent control system is
restarted following manual operation or following
the execution of an automatic function.

Setting the limit value for brightness

Only the relevant, current brightness can be selected
as the limit value for the brightness. When this value is
exceeded, the roller shutter moves down to the sun
sensor.
If the sun LED flashes slowly, the set limit value has
been exceeded.
If the sun LED flashes slowly, the brightness on setting
the limit value lay outside of the measuring range. The
limit value is automatically set to the measuring range
limit.
To define the current brightness as the limit value,
simultaneously press the
The current brightness is stored as the limit value.
Switching the brightness-dependent control
system on and off
To switch the brightness-dependent control system
on or off, press the
seconds.
If the sun LED lights up, the brightness-dependent
control system is switched on. If the sun LED does not
light up, the brightness-dependent control system is
switched off.
Following manual operation or the execution of
an automatic function, the brightness-dependent
control system is switched off.
Switch the brightness-dependent control system on
again following manual operation or the execution of
an automatic function if you would like to use the
brightness-dependent control system.
Using the device
+ buttons.
button for approx. two
55