Securing The Device To The Wall; Connecting The Sun Sensor - Superrollo GW70 Gebrauchsanleitung

Securing the device to the wall

ATTENTION
Damage to the belt due to inclined
installation of the device.
Make sure that the device is installed
vertically on the wall.
Check whether the device can be installed vertically
on the wall using the existing drill holes.
If the device cannot be installed vertically using the
existing drill holes, drill new holes.
Hold the device in the location on the wall at which
you would like to install it.
Check the alignment of the device using a spirit
level.
Make sure that you hold the device vertically.
Make sure that the belt is routed vertically into the
device.
Mark the two drill holes.
Remove the device from the wall again.
Drill the two holes using a 6 mm drill bit.
Insert the plugs.
Hold the device on the wall so that the holes drilled
in the wall match up with those on the device.
Screw the device on firmly.

Connecting the sun sensor

Proceed as follows to connect the sun sensor:
Insert the sun sensor connector into the connection
socket on the lower side of the device.
Press the sucker with the sensor onto the inner side
of the window.
Installing the device
49