Getting Started - Bresser MeteoTemp Proj Bedienungsanleitung

5. Five languages for weekday display: GE, EN, SP, FR, IT
6. Up to 3 outdoor sensors can be connected
7. Backlight

9. Getting started

1. Place the base station as close as possible to
the remote sensor.
2. Establish the power supply of the base station:
a. If you are using the power adapter (re-
commended), plug it into the power jack
and insert the USB cable into the port on
the device's back.
b. If you are using batteries:
1. Remove the battery compartment cover.
2. Insert 2 new AAA size batteries into the
battery compartment according to the
polarity mark in the battery compart-
ment.
3. Replace the battery compartment
cover of the base station.
3. Remove the battery compartment cover of the
remote sensor.
4. Insert 2 new AAA size batteries into the battery
compartment according to the polarity mark in
the battery compartment.
5. Press the °C / °F key to adjust the temperature
unit on the sensor's display.
6. After the batteries are inserted into the base
station, all LCD segments will appear for 1
second, and during that time, the backlight
will light up. Indoor temperature and humidity
detections will start.
7. After approx. 3 minutes, the RC signal will be
received by the base station.
8. After approx. 7 minutes, the current time and
date will be synchronised automatically with
the DCF time signal transmitted from Europe.
9. Now replace the battery compartment cover of
the remote sensor.
EN
9