Displaying Channels; Displaying Current Indoor And Outdoor Temperature And Humidity - Bresser MeteoTemp Proj Bedienungsanleitung

NOTE: Once the channel is assigned to one remo-
te sensor, you can only change it by repeating the
pairing process.
If no signals are received, "—-" will appear on the
base station's display. In case of any error, relo-
cate the base station or the remote sensor. Make
sure both items are within the effective range of
approx. 60 meters.
After several unsuccessful attempts, remove
the batteries of both items and start the pairing
process again. Try out where your weather station
receives the signals best, keeping possible inter-
ference sources in mind.

19. Displaying channels

By default channel 1 is displayed on the base
station's screen. In normal mode, press the [
DOWN/RF] key to change from one channel to the
next. The sequence is:
18
CH1 CH2 CH3
In channel auto-change mode, channels change
automatically every 4 seconds.
20. Displaying current indoor and
outdoor temperature and humidity
Change into setting mode to change the tempe-
rature unit to Celsius or Fahrenheit. (see chapter
"Setting mode").
The indoor temperature and humidity will be
displayed permanently. The outdoor temperature
and humidity can be displayed separately or
automatically for the connected remote sensors
(read more in previous chapter).
• Outdoor temperature range: -20 °C to +60 °C
• If the temperature is below -20 °C the screen
will display LL.L, if it's over +60 °C the screen
will display HH.H.
channel auto-change mode.