Pairing Remote Sensors With The Base Station - Bresser MeteoTemp Proj Bedienungsanleitung

the projected data will be displayed on the dark
background as shown in Fig. 1.
2. While the projection is on, press the [snooze.
light] key to rotate it by 180°.
3. Adjust the quality of the projected data by
turning the focus wheel.
Fig. 1
18. Pairing remote sensors with the
base station
The base station can operate with up to 3 connected
remote sensors and show their data on its display.
Each sensor must be set to a diff erent channel.
1. Place the sensor as close as possible to the
base station.
2. Remove the battery compartment cover of
the remote sensor and make sure there are
batteries inside.
3. Choose the channel using the channel slide
switch.
4. Press the TX key to initiate the RF signal.
5. Replace the battery compartment cover of the
remote sensor.
6. In normal mode and while the correct channel
is displayed on the LCD, press and hold the
[ DOWN/RF] key on the base station.
EN
17