Snom m3 Bedienungsanleitung Seite 69

or near a television, VCR, or
microwave oven.
5. Do not expose the equipment
to direct sunlight.
6. Do not place equipment on an
unstable cart, stand, or table.
7. Adjust only those controls
referred to in the operating
instructions. Improper adjust-
ment of other controls may
result in damage and may
require extensive work to
restore equipment to normal
operation.
8. The equipment may get warm
when batteries are being
charged. To avoid damage,
it is recommended that the
product not be placed on
antique or veneered wood.
9. The location of the base unit
of the phone should be close
to a phone jack, a personal
computer, and a continuous
power outlet (an AC outlet
that does not have a switch to
interrupt power).
10. Keep base and handset
away from sources of electri-
cal noise such as motors or
fluorescent lighting.
fcc And other
informAtion
This equipment complies with
Parts 68 of the FCC rules and
the requirements adopted by
the Administrative Council for
Terminal Attachments (ACTA).
This device complies with part
15 of the FCC rules. Operation
is subject to the following two
conditions: (1) This device may
© snom technology AG 2007
not cause harmful interference,
and (2) This device must accept
any interference received,
including interference that may
cause undesired operation.
Privacy of communications may
not be ensured when using this
phone.
These limits are designed to
provide reasonable protectiona-
gainst harmful interference in
a residentialinstallation. This
equipment generates, uses
and canradiate radio frequency
energy and, if not installedand
used in accordance with the
instructions, maycause harmful
interference to radio commu-
nications.
However, there is no guarantee
that interference will not occur
in a particular installation. If
this equipment does cause
harmful interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user
is encouraged to try and correct
the interference by one or more
of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation
between the equipment and
receiver.
• Connect the equipment into
an outlet or on a circuit dif-
ferent from that to which the
receiver is connected.
• Consult the dealer or an expe-
rienced radio/TVtechnician for
help.
69
•