IFM Electronic AS interfoce AC2480 Montageanleitung Seite 6

Addressing
At the factory the address is set to 0.
Addressing with the addressing unit AC1144
The module can be addressed via the addressing cable (E11378). When
used with the FC isolation displacement connector E70096 this connec-
tion cable enables connection to the yellow AS-i cable.
If the slave is used with a master of the new generation (version 2.1),
an address between 1A and 31B can be selected by means of the
AC1144 addressing unit.
If a slave with the ID code "A" (extended addressing mode pos-
sible) is used with a master of the first generation (version 2.0),
the parameter P3 must be 1 and the output bit D3 = 0*. The
output bit D3 must not be used.
If a slave with the ID code "A" (extended addressing mode pos-
sible) is used with a master of the first generation (version 2.0),
an address between 1 and 31 must be assigned to this slave.
* default setting
6
PAGE