Werbung
FRoNT
oPEN ClosE
oPEN
ClosE
4
FRoNT
oPEN ClosE
ClosE
oPEN
English
To oPEN/ClosE shIElD
Pull outward on lower left side of shield to release
latch system and then raise the shield. To close the
shield, push down the shield until the shield is fully
latched
WARNING:
If your shield becomes too scratched or
uncleanable, replace it with a new one. Impaired
visibility causes accidents. Use a solution of
mild soap or detergent and lukewarm water to
clean your shield. Rinse well with clean water,
and wipe off with a soft cloth. Never use petrol,
thinner, benzene or any other solvents. There
are many "aggressive" cleaners on the market,
including some supposed to be specifically for
use on shield. Arai strongly recommends that
you do not use any such products to clean your
shield as some of their ingredients may have
damaging effects on the shield and other plastic
parts installed on your helmet. Do not apply
stickers or adhesive tape to the shield, as this
will weaken the hard coating. If tinted, the shield
is for daylight use only.
To oPERATE BRoWVENTs
The Browvents are operated from fully closed
through intermediate, to fully open positions by
simply pulling the vent control down to open,
pushing up to close.
To oPERATE ToP VENTs
Simply push the switches/levers on each vent to
open/close the vents.
Werbung
