Werbung
16
English
Position the plastic chinstrap anchor cover over the
steel anchor and push the cover in the anchor until
the tab on the back of the cover snaps fully home.
To REMoVE/REPlACE CoMFoRT
lINING
X-TEND RAM / XC RAM
The comfort lining is secured to the helmet by 4
plastic bosses.
To remove the lining, undo 4 bosses by grasping the
lining as close to each boss as possible and
pulling straight up. Note the fore & back, top &
bottom sides of the lining for replacement.
To wash the comfort lining, put it into lukewarm
water with small amount of laundry soap or your
own shampoo and wash gently by hand. Rinse well
with fresh water and wipe off with a soft cloth. Dry
it in the shade at ambient temperature.
WARNING:
Never use petrol, thinner, benzene or any other
solvents.
To replace the lining, place the 4 bosses over their
plastic receptacles and push them home.
WARNING:
When reinstalling the comfort lining, be sure
the lining is properly positioned along the inside
shape of the EPS (a.k.a. Styrofoam) liner. If the
comfort lining is not properly installed, the frame
of the comfort lining may fold when you put on
and take off the helmet, which may injure your
skin, etc. Whenever you feel something is wrong
with the comfort lining, check that the lining is
properly installed.
Werbung
