thyracont VD810 Betriebsanleitung Seite 42

42
Measurement data will be stored with this adjustable time interval after the data
logging is started. The edited value must finally be confirmed with the "OK"-key.
Logging Auto Stop
Logging Mode
Logging Interval
Logging Auto Stop
Datasource
This function will terminate data logging automatically after an adjustable time li-
mit.
In the first step the function has to be enabled or disabled. To enable select "On"
and then "Arrow right" to switch to the adjustment of the time limit. The edited value
must finally be confirmed with the "OK"-key.
In order to log data without time limit select "Off" and confirm. Data logging can
then be stopped manually as described in chapter 4.3.
Logging interval and required logging period should match to avoid
unnecessarily high data volumes!
Datasource
Logging Mode
Logging Interval
Logging Auto Stop
Datasource
In this menu you can select the data sources for data logging, i.e. if absolute pres-
sure, relative pressure or both should be recorded. The selection must finally be
confirmed with the "OK"-key.
VD810-USB-240130
Logging Auto Stop
i
If enabled and the device is in Logging
Mode, it will stop logging and shut down
after the chosen time limit is reached.
On
00 :3 0 [hh:mm]
Data Source
i
Select the data source(s) to be logged.
Absolute