hanseatic HWC86ECBA Gebrauchsanleitung Seite 50

Page EN-22 Start-up
Connecting the appliance
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if it
shows visible signs of damage, e.g.
–
the power cord is defective,
starts smoking or there is a smell of
–
burning,
makes unfamiliar noises.
–
In such cases, remove the mains plug
from the socket and contact our ser-
vice department (see page EN-25).
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
Do not kink or pinch the mains cord
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fire and damage to property.
Connect the appliance only to a prop-
■
erly installed and earthed electric sock-
et. Do not connect to a multi-socket
extension cable or a multi-socket plug.
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to flow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
The temperature indicator (7) will light up.
The appliance is switched on.
You will find all important information
about operation from page EN-12.