Klarstein CONTEMPO Bedienungsanleitung Seite 30

EN
• Installation work and electrical wiring
must be carried out by qualified
persons in accordance with all
applicable regulations and standards,
including the design of the equipment.
• Do not exhaust air into a flue from
other appliances that burn gas or other
fuels.
• The regulations regarding exhaust air
flow must be met.
• The extractor hood must be installed
at a minimum distance of 65 cm above
the cooking surface of a hob.
• The extractor hood must be installed
at a maximum distance of 75 cm above
the cooking surface of a hob.
30
Installation in the cupboard
• Drill one 130 mm diameter hole and four 3.5 mm diameter holes as shown
below.
ATTENTION: If your extractor hood is running in recirculation mode, it is
•
not necessary to drill a 130 mm diameter hole.
• Use the 4 screws to attach the cooker hood to a kitchen cabinet. Check that
the screws are correctly seated by temporarily securing the cooker hood. Once
properly installed, attach the hood and tighten the screws if necessary.