Startup / Operation - BOMANN DU 659 IX Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für DU 659 IX:

Bedienungsanleitung (20 Seiten)

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

• Place the outer duct with the fixed rail (3) onto the extractor hood (Fig. E). Fasten

Place the outer duct with the fixed rail (3) onto the extractor hood (Fig. E). Fasten the rail (3) to the wall

Place the outer duct with the fixed rail (3) onto the extractor hood (Fig. E). Fasten

parallel to the other rails (1+2).

• Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct

Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct

is aligned with the vents at the top. Determine the extension length of the duct cov

is aligned with the vents at the top.

duct or sliding back into the outer duct.

• For extraction mode, correctly position the flexible

For extraction mode, correctly position the flexible extraction hose (not supplied).

• Pull the inner duct cover up and

screwing in the plate screws (7) (Fig. F)

I I I I nstalling the activated carbo

nstalling the activated carbon filter for recirculation mode

nstalling the activated carbo

• Remove the aluminum grease filter.

Remove the aluminum grease filter.

• Place the carbon filter onto the air intake of the extraction duct. Make sure that the mounting pins on the

Place the carbon filter onto the air intake of the extraction duct. Make sure that the mounting pins on the

extraction duct engage the mounting slots of the carbon filter. Turn the respective filter clockwise until it

clicks into place.

• Reinstall the aluminum grease filter

NOTE

NOTE: : : :

The activated carbon filter absorbs odours

Electrical connection

WARNING:

• The installation to the mains supply must conform to the local standards

The installation to the mains supply must conform to the local standards and regulations.

• Improper connection may cause to an

Improper connection may cause to an electric shoc

• Do not modify the appliance plug

an authorized specialist.

• The accessibility of the power plug must be ensured in order to disconnect the

The accessibility of the power plug must be ensured in order to disconnect the appliance

supply in case of an emergency.

• Ensure that your mains power corresponds with the specifications of the appliance. The specifications are

Ensure that your mains power corresponds with the specifications of the appliance. The specifications are

printed on the rating label.

• Connect the mains cable to a properly installed and earthed wall outlet.

Connect the mains cable to a properly installed and earthed wall outlet.

Information to reduce the environmental effect of cooking

(acc. VO (EU) No. 66/2014 appendix I, No. 2)

Cooker hood

The diameter of the pot and pan floors should be according to the size of the cooking zone.

Determine the extension length of the duct cover by pulling up the inner

nd fasten the duct unit on the side to the previously

(Fig. F).

n filter for recirculation mode

um grease filter.

odours and must be replaced at least every six months

electric shock! k! k! k!

electric shoc

plug. If the plug does not fit properly to the outlet, let install a proper outlet by

. If the plug does not fit properly to the outlet, let install a proper outlet by

pan floors should be according to the size of the cooking zone.