BOMANN DU 659 IX Bedienungsanleitung Seite 20

NOTE NOTE: : : : Recomm Recommendations for preparation work endations for preparation work endations for preparation work endations for preparation work
NOTE NOTE Recomm Recomm endations for preparation work endations for preparation work endations for preparation work endations for preparation work
• When installing, ask another person
• Wear protective gloves to prevent injuries from any sharp edges. Wear protective gloves to prevent injuries from any sharp edges.
1
4
• Determine the position of the extractor hood centrally above the hob in conformance with the specified Determine the position of the extractor hood centrally above the hob in conformance with the specified Determine the position of the extractor hood centrally above the hob in conformance with the specified
safety distances.
• Mark the necessary holes for the wall mounting by using the supplied drill template and Mark the necessary holes for the wall mounting by using the supplied drill template and check them with a Mark the necessary holes for the wall mounting by using the supplied drill template and
spirit level.
• Drill Ø 8 mm mounting holes into
fasten the brackets with the screws
• Attach the suspension rail (1) for the hood body as well as the mounting rail with bracket (2) to the top Attach the suspension rail (1) for the hood body as well as the mounting rail with bracket (2) to the top Attach the suspension rail (1) for the hood body as well as the mounting rail with bracket (2) to the top
edge parallel to the rail (1) (Fig. A). Determine the extension length of the duct cover in advance! parallel to the rail (1) (Fig. A). Determine the extension length of the duct cover in advance! parallel to the rail (1) (Fig. A). Determine the extension length of the duct cover in advance!
• Before suspending insert the non
them.
For extraction mode: For extraction mode: For extraction mode: For extraction mode:
• Hereupon a flexible extraction hose flexible extraction hose (not supplied) with an inner diameter of Ø 150 mm must be attached
(Fig. B) and connected to the outside by the extraction outlet. connected to the outside by the extraction outlet.
• Hook the extractor hood into the suspension
• Remove the protective plastic from the telescopic duct. Remove the protective plastic from the telescopic duct.
• Fix the outer (lower) duct with the mounting rail without the bracket (3). The rail is fastened to the holes
provided from the inside of the duct. Screw in two plate screws (7) from the back (Fig. D). provided from the inside of the duct.
person to assist.
5
the wall for the respective brackets (1+2+3). Insert
screws (6).
insert the non-return valves (4) onto the extractor duct from above by gently bending return valves (4) onto the extractor duct from above by gently bending
suspension rail (1) (Fig. C). Check that it is secure
the mounting rail without the bracket (3). The rail is fastened to the holes the mounting rail without the bracket (3). The rail is fastened to the holes
2
6
with an inner diameter of Ø 150 mm must be attached
) from the back (Fig. D).
20
3
7
Insert the dowel pins (5) and
cure and horizontally level.