Werbung
®
CDSECTION
This mechanism has been newly designed to improve its
performance, so that pickup posture adjustment, laser power
adjustment and VCO adjustment are not required.
Setting the TEST Mode
(Refer to Fig. 25-1)
Pressing CALL button and CLEAR button simultaneously, set
the selector switch to CD. As a result the whole indication
appears for 0.5 sec, and 'TEST MODE 0" (1) is indicated.
Then once press the PLAYbutton. As a result 'TEST MODE 1"
(2) is indicated, and the laser lights.
If the PLAY button is pressed again, 'TEST MODE 2" (3) is
indicated, and Focus starts (Focus Servo On).
When the PLAY button is pressed (third time). 'TEST MODE
3" (4) is indicated, and the spin motor starts (Spin Servo On).
When the PLAY button is pressed (fourth time), 'TEST MODE
4" (5) is indicated, and Tracking Servo is turned on.
When the PLAY button is pressed (fifth time), track No. and
time are indicated (6).
The sixth key input and subsequent key inputs are not
accepted.
When the STOP button is pressed, pertinent operation stops,
resulting in stop state. In this case the pickup does not slide,
and 'TEST MODE 0" is indicated.
.
While the FAST FORWARD (REWIND)button is pressed, the
pickup slides to outward (inward). While this operation is
executed, the test mode indication does not change.
Caution: The above-mentioned TEST Mode cannot be set
unless the CD cover open-close switch is set to ON.
-25-
CD-X9G/H/E
DO
lE5l
TEST M:>DE 0
TEST M:>DE 4
TEST M:>DE 5
Figure 25-1 TEST MODE
Werbung
