CONDTROL VECTOR 100 Bedienungsanleitung Seite 28

Vector 100 CONDTROL
LASER DISTANCE METER
EN
User manual
WARRANTY
All CONDTROL GmbH products go through post-production control and are
governed by the following warranty terms. The buyer's right to claim about
defects and general provisions of the current legislation do not expire.
1) CONDTROL GmbH agrees to eliminate all defects in the product, discovered
during the warranty period, that represent the defect in material or workmanship
in full volume and at its own expense.
2) The warranty period is 24 months and starts from the date of purchase by the
end customer (see the original supporting document).
3) The warranty doesn't cover defects resulting from wear and tear or improper
use, malfunction of the product caused by failure to observe the instructions of
this user manual, untimely maintenance and service and insufficient care, the
use of non-original accessories and spare parts. Modifications in design of the
product relieve the seller from responsibility for warranty works. The warranty
does not cover cosmetic damage, that doesn't hinder normal operation of the
product.
4) CONDTROL GmbH reserves the right to decide on replacement or repair of the
device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by CONDTROL GmbH warranty period is not
renewed or extended.
7) CONDTROL GmbH is not liable for loss of profit or inconvenience associated
with a defect of the device, the rental cost of alternative equipment for the period
of repair.
This warranty applies to German law except provision of the United Nations
Convention on contracts for the international sale of goods (CISG).
In warranty case please return the product to retail seller or send it with defect
description to the following address:
CONDTROL GmbH
Im Wiegenfeld 4
85570 Markt Schwaben
Deutschland
28 28